1:  6278f3ed0d27 ! 1:  a74214b5b8e0 wifi: ath12k: Add EHT capabilities to scan probe frame
    @@ Metadata
      ## Commit message ##
         wifi: ath12k: Add EHT capabilities to scan probe frame
     
    -    Currently, ath12k does not set the EHT flag in scan channel
    -    information and does not send WMI_VDEV_SET_IE_CMDID with the EHT
    -    Capabilities element configuration. As a result, EHT-capable STA
    -    Probe Requests do not contain the EHT Capabilities element.
    +    ath12k hardware scan Probe Request frames do not include the EHT
    +    Capabilities element. Without this element, an AP cannot identify the
    +    STA as EHT-capable during active scanning and may omit EHT-related
    +    information from its Probe Response. This can result in incomplete scan
    +    information and prevent userspace from correctly determining the AP's
    +    EHT capabilities.
     
    -    Without this element, AP can't identify the STA as EHT-capable
    -    during active scanning and may omit EHT-related information from its
    -    Probe Response. This can result in incomplete scan information and
    -    prevent userspace from correctly determining the AP's EHT capabilities.
    +    For firmware to include the EHT Capabilities element in scan Probe
    +    Request frames, two conditions are required:
     
    -    Set the EHT scan flag and configure the EHT Capabilities element so
    -    that ath12k includes it in STA Probe Request frames.
    +      - The scan channel must have WMI_CHAN_INFO_ALLOW_EHT set, which allows
    +        firmware to add the EHT Capabilities element to Probe Request frames.
    +      - The EHT Capabilities element must be configured on the vdev through
    +        WMI_VDEV_SET_IE_CMDID, so firmware can use it when building Probe
    +        Request frames.
    +
    +    Set WMI_CHAN_INFO_ALLOW_EHT for channels when 11be is supported by
    +    firmware and not disabled by ACPI. Also configure the EHT Capabilities
    +    element before each hardware scan when the element is present in the
    +    mac80211 scan IE buffer.
    +
    +    Firmware retains the configured element in the vdev context until it is
    +    replaced or the vdev is deleted. However, ath12k scans may either reuse
    +    an already started vdev or create a temporary scan vdev that is cleaned
    +    up after scan completion. Sending WMI_VDEV_SET_IE_CMDID for each scan
    +    request ensures correct behavior in both cases.
     
         Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.1.c7-00108-QCAHMTSWPL_V1.0_V2.0_SILICONZ_UPSTREAM-3